L298N H-Bridge Dual Motor Driver (Red)

Description:

This module is based on L298N,high voltage, high current dual full bridge driver which can be used to drive a DC motor and stepper motor, relay coil inductive load; using standard logic level signal control; having two enable control end allow or prohibit the work has a logic device power supply input terminal, in the case regardless of the input signal affect the internal logic circuit portion to operate at a low voltage; can be an external sense resistor, the amount of change in feedback to the control circuit.

This module integrates a built-in 5V power supply. When you drive voltage of 7V-35V can onboard 5V logic supply, do not input voltage when using onboard 5V power supply, the +5 V power supply interface, but leads to 5V voltage for external use

When ENA is HIGH, IN1 IN2 control OUT1 OUT2

When ENB is HIGH, IN3 IN4 control OUT3 OUT4

Technical Specification:

• Module: Dual H bridge motor drive module
• Work mode: H bridge drive (double road)
• Main control chip: L298N
• Logical Voltage: 5V
• Drive Voltage: 5V-35V
• Logical Current: 0mA-36mA
• Driving Current: 2A(MAX single bridge)
• Storage Temperature: – 20 ℃ to + 135 ℃/-4 – 275℉
• Maximum Power: 25W